Lotus,
You won't get a more 'objective' source until the camera is released to the wild. But let's take a look at the 'relative points' theSuede brought up:
Positives for the Foveon:
-Much nicer noise pattern, chromatic noise is perfectly scaled to pixel size (until you start correcting for the abysmal colour hue resolution, then it's actually worse than Bayers).
-Less (but not totally removed) risk of colour moire.
Negatives for the Foveon:
-Low sensitivity - noise performance is pretty poor
As mentioned in the article, Foveon had been working hard on cell phone images for the last couple years before being bought by Sigma. Hard as defined by the majority of their resources. So they've been dealing with smaller pixels. One would expect that they have worked on noise performance. And in fact, one can read Foveon patents on reducing wiring on the chip to achieve exactly that. Coupled with the fact that they've gotten progressively better in noise performance from the SD14 to DPn's to the SD15---all using essentially the same chip---indicates that they're making progress in both the in camera imaging pipeline as well as their software.
-Low colour hue sensitivity
Again, colors are getting better (and easier) with every iteration of camera. My SD15 profiles very 'neutrally' when shooting a ColorChecker, even...
-VERY high metamerism errors (bad for difficult lights like fluorescents and such)
...under different spectral conditions. In general, a good set up lookup tables are probably responsible for Sigma getting the SD15 to be easier to work with. AutoWB is working well for a refresing change too.
-Very sensitive to light incident angles.
This is just a internet myth, put together by people who flunked trig and physics. In the dSLR, the registration distance is 44 mm on a chip that is 22 mm wide. That angle on the edge (not the corner---I'm too lazy) is 14 degrees from perpendicular. When light goes from a low refractive index medium to a high one (Si has an index of 4.5 if I remember correctly), it gets bent to the perpendicular. Strongly, in this case--to an angle of 2.6 degress from perpendicular. Angular incidence is not an issue.
For short registration distances (like a compact), there can be an angle of incidence problem, but I believe it's mainly a reflection issue (chips are shiny). Most antireflective coatings are wavelength dependent, so that causes complications.
I was very impressed with regards to the interview, and thought that the team gave pretty good, non marketing details.