p.16 #1FE 100-400 issues with and without 1.4 extender
I agree with jhinkey and kdrk888. It looks like this is about the best we can expect.
Maybe there are some units that don't display the same vignetting characteristics, and it looks like our newer replacements are improved but still exhibit some, so I'm not sure what Sony might be able to do.
OTOH, it couldn't hurt to call them and ask if for no other reason than to satisfy yourself.
p.16 #2FE 100-400 issues with and without 1.4 extender
I haven't had time to remove the rear baffle of the TC to do a final check, but it seems like a custom profile is still needed to remove the last bit of annoying corner vignetting pattern. I say patter because it's not a simple light fall-off - there are stripes due to some internal reflection of some sort.
p.16 #4FE 100-400 issues with and without 1.4 extender
Looks like you removed the file from Dropbox. I had a similar issue and after a couple of trips to Sony pro support/precision camera Sony engineers said it was "normal" and nothing could be done about it.
eyal wrote:
Don't want to hijack this thread but hoping those with experience and interest in the 100-400 can look at some blue sky shots for me.
I've been shooting with the 100-400 for almost a year now and found it to be a good lens but had noticed some odd vignetting/bright spots on uniform areas such as a blue sky. I was out this morning shooting the full moon setting and decided to do a quick check of the sensor on the blue sky to make sure it had no dust spots. I ran it from 5.6-40 and, on getting home, found the vignetting was obvious even at f/8 where it appears more as a bright circle in the middle of the frame.
I put together a pdf (a slideshow movie file showed bad digitization/compression) from Lightroom with a sequence at 100mm where it is not visible to my eyes, at 400mm where is is quite obvious and also tested against my Canon 200 as it is the only other long focal length I have. I have lens compensation flagged on (Auto) in camera and LR had the Enable Profile Correction checked with both distortion and vignetting at 100.
p.16 #5FE 100-400 issues with and without 1.4 extender
And a good trick to see the vignetting/lens issues (I still believe the issue is cause by the lens itself, the TC only magnifies it) which is also a good trick to see dust spots better when cleaning your sensor, after importing the picture into photoshop just use the Equalize function to see it better, and then you can further "enhance" the results by changing brightness and contrast. Here's an example. Let me know what you think.
Imported RAW into LR, exported as jpg, no changes were made
Imported into photoshop from LR and used Equalize
After using Equalize, I set brightness to -100 and contrast to 50