Hey guys, I know that this was addressed and phase played it off as a problem with adobe... So let me explain my problem and it's with phases program..
Alright, in lightroom the lines show up as blue, and you process the files and the blue line is still in the file (blue line is in the middle of the file in the horizontal position of the sensor the line runs up and down vertically). This problem doesn't go away even after the file is processed (BTW there are other lines in the file that are more faint and blue but I think they're ISO banding)..
Now with phases new capture one software, I get this single line that looks like a perfect straight scratch down the middle of the sensor. This line doesn't go away. It's noticeable in small viewing sized shots, and it's very detailed in 100% crops, even with the tiff is processed the lines still there, and very visible.
Any solutions?
Says main firmware is 2.5 then there are other firmwares and the CLD firmware or whatever you call it, it's at 2.2.3
As far as I know the sensor is made of 6 smaller sensors which are stitched together. Normaly the thin line between them should be invisible after processing. Maybe C1 would work better. I suggest you go to LL forum and ask one of the "phase" people there
Sent the press release above to a few forms.. I think the answer is calibration of the camera and firmware but I haven't purchased the camera yet, so I don't know if I'm going to or not.. Just looking at the tests I took from today.
No warranty, so I want a definite answer before I take the plunge.
adamdewilde wrote:
Sent the press release above to a few forms.. I think the answer is calibration of the camera and firmware but I haven't purchased the camera yet, so I don't know if I'm going to or not.. Just looking at the tests I took from today.
No warranty, so I want a definite answer before I take the plunge.
Thanks for the advice thus-far though!
Well I would certainly want this issue solved before I buy, especially without a warranty
