Archive 2012 · Magnet on Canon Pixma Pro 2000 Mark II

cilaes
Offline
•
Upload & Sell: Off

p.1 #1 · Magnet on Canon Pixma Pro 2000 Mark II

I just received my Pixma Pro 2000 and it prints AMAZING photos.

However, I bought some 12x18 0.30mm magnet paper, and just did a trial run using a graphic I made to print a car magnet and the ink was very wet and ran. It looked horrible. I immediately cancelled printing and was able to wipe the big magnet paper off using hand sanitizer and a rag.

Is this possible? What do I have to configure if so? I can't find anything about this online, aside from the fact that it can print up to .30mm paper.

Aug 21, 2012 at 05:50 PM

anthonygh
Offline
• • •
Upload & Sell: Off

p.1 #2 · Magnet on Canon Pixma Pro 2000 Mark II

Have you put the paper in the right side up?

Aug 21, 2012 at 08:37 PM

cilaes
Offline
•
Upload & Sell: Off

p.1 #3 · Magnet on Canon Pixma Pro 2000 Mark II

I appreciate the response, but.... really? Of course I did. It's magnet paper. 1 White site, one magnet side.

The white side is fairly smooth and is not holding ink.

The white side is the side that is supposed to be printed on.

The white side is the side that I have up going through the printer.

Thanks again.

Aug 22, 2012 at 08:36 AM


FM Forums \| Post-processing & Printing \| Join Upload & Sell