lifeandmylens wrote:
geekcop wrote
lifeandmylens wrote
geekcop wrote
These are from the second roll of 500T but mostly shot in daylight. I don't like the colors outside as much as the other roll and I wish I had used an 85 filter to fix the white balance. I made changes in LR but it was a drag. Did you push these? Or heat up your remjet? They look a little grainy for daytime. The 85(b) filter definitely helps using it in daylight and is necessary in shade. Remjet remover was at 80F
I messed up and the Ecn-2 developer was only 100F
I added 1-minute dev time as a guess to compensate. So, 4:20. So even though the temp was low it was probably a slight push. Fresh one shot developer was used. Film was allegedly fresh and not expired. Agitation was first 30 seconds and then 5 seconds every 30 seconds thereafter. Open to any suggestions. I follow your instructions for Ecn. Gotcha! I should probably update that guide, I've changed some things. One of which is I use the remjet pre bath at room temperature. I don't heat it at all. As for the film, you can see on the rebate the year it was made if you're ever curious. I also a prefer a shorter dev time and lower EI. So for 500T, I rate it at 400 and dev for 3:00-3:15 @ 106º.
Thanks for that info. I have a lot (100+) rolls of Vision3 film so if you’d be willing to update the guide I’d be forever grateful. I also use it for most of my C-41 too. So it’s important that I keep zeroing in my development technique.