Timphoto wrote:
Just to make certain I understand correctly.
If I code my Voigtlander 35/2 APO Lanthar with 011110 and my M10 Monochrom reads it correctly, the camera will assume I've attached a Summicron-M 35mm f/2 ASPH.
There's no way for the camera to determine I'm using a Voigtlander but it will report the correct f stop, focal length, ISO, and present the correct RF frames.
If you code your Voigtlander lenses they will be seen by the camera as the Leica lens you coded it to. The camera will apply the Leica corrections for vignette and distortion. These are usually reasonably close to those of the corresponding Voigtlander lenses.
The EXIF data will display as follows.
1.) The Coded for Leica lens model
2.) The coded for Focal length
3.) The camera doesn't get any electronic information from either a Leica or Voigtlander lens. Based on exposure and other camera settings like Shutter Speed and ISO the camera will calculate an estimated aperture. Unfortunately, this is often wrong and unreliable whether using Leica or Voigtlander lenses.
4.) The camera know the Shutter Speed the image was shot at so this will be correctly reported.
5.) The camera knows the ISO the image was shot at so this will be correctly reported.
Since you will code the Voigtlander lens to the same values as a Leica lens with the same Focal Length, the Range Finder will show the appropriate Frame Lines when shooting.
I hope this helps clear up these issues for you.
Steve