Elijah wrote:
I'm a CNC machinist and knowing my RRS stuff is machined on a CNC, made in USA makes me happy; RRS FTW.
I was never a fan of cast/forged items from some third world country like China... there's nothing better than a product that's machined, anodized and made in the US of A.
Makes me feel like a million dollar photographer.
Well, both the Sunwayfoto as well as the RRS L-bracket are CNC-machined from 6061 Aluminium. I'm pretty sure that it doesn't take hours for a craftsman to put the aluminium block into the machine and start it up to do its work.
Also, the anodising process is fairly cheap as you can simply dip a hundred L-brackets into one bath.
So, yeah, while US production workers make much more per hour, the CNC machine they use to fabricate the L-brackets likely came from China (and it might just as well be the exact same machine that sunwayfoto uses) and doesn't cost much more to run than it does in China.
re ballheads from Sunwayfoto:
I haven't used one yet. After studying an incredibly extensive German tripod head test (Traumflieger), I went with the Tiltall BH-07 that won the entire comparison against 36 other heads, including the likes of an RRS 55 for 4x the cost and weighing 3x as much (basically because of these drawbacks, because the RRS had slightly better dampening and could carry 500gr more). The RRS 40 was so far off that it's outright laughable but not as ridiculous as the Gitzo head they tested.