bigbearbear Offline Image Upload: Off
|
p.1 #11 · FOllowup CF Reader - WTF?? | |
Hello Jeremy, sorry to hear that you are having troubles with the CF card reader and CF cards. Interestingly enough, another FM member had problems when using the same cards you're using: http://www.fredmiranda.com/forum/viewtopic_archives.php?TopicID=151440&page=0#1227604
From what you have described, I will be very careful with the Lexar card you are currently using. I am assuming that you ran the card recovery software using the same Apacer card reader and the images were recovered alright? If so, chances are that the Lexar card is starting to go bad or has some defect that did not show up until you tried moving it from the camera to the reader.
The way CF cards work is like your computer hard drive. It has a file system (FAT32 for high capacity CF cards) which uses a look up table (File Allocation Table - FAT) to remember where the various files are stored. Typically when you do a format on your CF card, the camera or computer simply deletes the old FAT and creates a new one. This way, newer images simply overwrites regions on the card that used to hold older images and the new location recorded in FAT.
In your case, it sounds like the FAT was corrupted and hence your images were not showing up. When you run the recovery software, it bypasses the FAT and went hunting for the files on card, which were still there. For this to work, the card reader has to work properly or you would have hosed the CF card.
Good luck!
Bigbear.
jeremy_clay wrote:
So! I thought I would mention this...
As you may know, previously I was attempting ot get Nikon RAW off my Canon CF card and only had a Canon camera to use, without a CF reader. At a dead end, I sucked it up and bought one. All went well there, woo!
Today, however, I went out shooting. ALl was fine, no problem...got home, all fine, I had only shot 19 images or so. Could preview the images on my cam LCD, etc. Was going to plug the USB into the cam and do it 'old school', but decided "What the helL! I've got my shiny new Apacer card reader!" and yanked out the CF card, plugged it in. Double clicked on I: drive, my CF removable, and it timed out trying to access it. THought, 'odd', and plugged the CF back into the cam. CF error. .....wtf
Long story short, Lexar Image Rescue 3 barely saved my ass. Will never use the card reader for anything ever again if I don't have to.
PS - I don't blame anyone here, I'm sure it's just bad luck..but WTF?>!?!
|