Central black patch size 3mm x 6mm approx.
100% crop. No sharpening or enhancements done.
Printed at 600dpi in a laser printer, A4 paper.
Pasted on a plank, kept inclined 45 deg.
Top portion farther from lens, bottom portion nearer.
Phase detect focus on central rectangle, single point focus.
Distance from camera D3100 to target 10 ft.
Lens @600mm. Aperture 6.3, ISO 100.
Camera on solid support.
Focus camera through cable switch half press, hold a black
card in front of lens, fully press cable switch, after 2 sec move away card,
after 4 sec bring back card in front, within 1 sec release switch.
This is done to avoid effect of mirror vibration. Room was lit with a 40W tubelight.
Conclusion: Sharp central rectangle. DOF effect is seen in the form of gradual out-of-focus of other black lines and circles above and below the rectangle. Since the central rectangle is sharp, this also indicates that there is no front or back focus issue. (In fact, my D3100 had an issue and I corrected it by adjusting the screw inside the camera mirror area. It needs lot of patience and setting up to do the screw adjustment. I would not recommend it as a general suggestion.) No corrections done in the lens with the USB dock. Lens calibration is original sigma factory default.
Couple of shots with the Sigma 150-600 S from the Thunderbirds performance at the Great Pacific Airshow over the weekend in Huntington Beach, CA. Th lighting was pretty horrible though!