Daan B wrote:
It would probably mean I have to move the entire lights + modifiers around some more... I agree, an inconvience at best...
There are a lot of ways to make that a small issue, especially with a small battery pack like the AcuteB (or Ranger, for that matter) that don't end up tethered to power. Just hang the pack off of a decent rolling stand and suddenly moving it around the studio from setup to setup is no sweat at all. Almost easier than swapping modifiers.
IIRC there is a speedring adapter that makes it possible to mount the Deep Octa on the AcuteB... But why would I want to do that?
Because the Deep Octa is a modifier that doesn't really have a direct analog in other manufacturer's lines. Much like the Mola beauty dishes have a different look than Profoto's or Elinchrom's, the Deep Octa has a look that people cross brand lines for.
Any other negatives?
Keep in mind that the AcuteB doesn't have a huge battery capacity and that plugging it into power while using it doesn't mean that you're running it off AC...you're just trickle-charging it at the same time as you're draining the battery. You can expect ~150 full-power pops from a charge at best, so using it as a studio pack is only really feasible at low power and if you work slowly.
shatterkiss wrote:
Meaning with significant enough output to be worth using. With the AcuteB it isn't worth even turning on, especially given the battery drain.
Well it depends I guess... If I use a reflector on the AcuteB at 6 ft distance to the subject, maybe 90W will do the trick. OTOH, if I use a softbox at +9 ft from the subject, 90W is probably to weak. I will be using the 85W adapter for the AcuteB's modelling light, so it won't drain the accu at all.
But anyway, that is the reason for me to consider a RX next to the AcuteB... it has a 250W modelling light. So, the RX will have the Deep Octa glued to it and the AcuteB will be used with reflectors mainly.
I think this might just work, don't you think so?
On location I will be using the AcuteB with reflectors only.
shatterkiss wrote:
There are a lot of ways to make that a small issue, especially with a small battery pack like the AcuteB (or Ranger, for that matter) that don't end up tethered to power. Just hang the pack off of a decent rolling stand and suddenly moving it around the studio from setup to setup is no sweat at all. Almost easier than swapping modifiers.
My thoughts exactly
Because the Deep Octa is a modifier that doesn't really have a direct analog in other manufacturer's lines. Much like the Mola beauty dishes have a different look than Profoto's or Elinchrom's, the Deep Octa has a look that people cross brand lines for.
As I said, I will be using the Deep Octa on the RX.
Keep in mind that the AcuteB doesn't have a huge battery capacity and that plugging it into power while using it doesn't mean that you're running it off AC...you're just trickle-charging it at the same time as you're draining the battery. You can expect ~150 full-power pops from a charge at best, so using it as a studio pack is only really feasible at low power and if you work slowly.
Most of my work is doing head shots or 3/4 body shots at close distances (3-6 ft). Since I use a DSLR with medium apertures mostly, I will be surprised if I go beyond 300 w/s anyway
Well, sounds like you are fairly far along in your decision, but I will chime in anyway.
Do you already own one of these kits, or both? If you only have one, why are you leaning toward picking up a kit by the other manufacturer, instead of more equip from the one you own?
I have Broncolor AC packs and Broncolor battery operated packs. Also a few monolights by Visatec (made by Broncolor.)
I really never use the battery packs along with the ac packs. I have used them once or twice for a hair light, etc. But I would rather just have all of the same type of units in the studio.
I know folks act like they are experienced and all and don't need no stinking modelling lights.
I do though, I like them and I and I use them in the studio. I like to be able to examine a scene closely, feather lights, etc. Especially if I am not shooting tethered. (The battery operated packs modelling lights are next to useless on location, except for a unit like the Bron Verso, etc.)
With the Broncolor packs, you can set 6 or more different levels of proportionality for the modelling lights. So if you have a 1600 ws pack and a 3200 ws, you can set the packs to output the correct relative amount of modelling light between the 2 packs.
Recycle times on the battery packs are slower too, especially once the battery gets drained. And if the battery does die, you might wind up shooting without your hair light, etc. for a few pops, unless you have your assistant watching them.
I tend to go through a lot of exposures in the studio, so I would need a few batteries.
I also like to keep my battery powered location kit packed up and ready to go! I **always** forget things if I use parts of it in the studio, then try to pack quickly and go on location.
I guess if you can only afford 2-3 units it might make sense to use the whole thing together in the studio. But you can probably pick up a cheap pack or monolight to round out the kit, and keep the battery version for location only. Even Broncolor has packs that you can get for $200 or less for filler-type units.
Anyway, just my experience based on how I actually use my equipment. Good luck!
mmurph wrote:
Well, sounds like you are fairly far along in your decision, but I will chime in anyway.
Do you already own one of these kits, or both? If you only have one, why are you leaning toward picking up a kit by the other manufacturer, instead of more equip from the one you own?
I have Broncolor AC packs and Broncolor battery operated packs. Also a few monolights by Visatec (made by Broncolor.)
I really never use the battery packs along with the ac packs. I have used them once or twice for a hair light, etc. But I would rather just have all of the same type of units in the studio.
I know folks act like they are experienced and all and don't need no stinking modelling lights.
I do though, I like them and I and I use them in the studio. I like to be able to examine a scene closely, feather lights, etc. Especially if I am not shooting tethered. (The battery operated packs modelling lights are next to useless on location, except for a unit like the Bron Verso, etc.)
With the Broncolor packs, you can set 6 or more different levels of proportionality for the modelling lights. So if you have a 1600 ws pack and a 3200 ws, you can set the packs to output the correct relative amount of modelling light between the 2 packs.
Recycle times on the battery packs are slower too, especially once the battery gets drained. And if the battery does die, you might wind up shooting without your hair light, etc. for a few pops, unless you have your assistant watching them.
I tend to go through a lot of exposures in the studio, so I would need a few batteries.
I also like to keep my battery powered location kit packed up and ready to go! I **always** forget things if I use parts of it in the studio, then try to pack quickly and go on location.
I guess if you can only afford 2-3 units it might make sense to use the whole thing together in the studio. But you can probably pick up a cheap pack or monolight to round out the kit, and keep the battery version for location only. Even Broncolor has packs that you can get for $200 or less for filler-type units.
Anyway, just my experience based on how I actually use my equipment. Good luck!
Well, I don't own any of these strobes/packs yet... Just comparing different options
I guess it would be most practical to have all the units from one manufacturer. OTOH, I wouldn't want to call my home studio a replacement for a "real" studio. My home studio is severly limited in space. There is room for 3 strobes max. Not a big deal, because I shoot most of my stuff on location. That is why I put my main focus on a location set that I can expand a little when shooting inside my home studio.
I do like to have modelling lights with sufficient power. At the moment Profoto wants to get rid off their Pro-B2's because they give a free Pro-head with them. This would give a modelling light of 250W. The downside is that the accu is quickly drained. So to each advantage there is a disadvantage.
Maybe I should let go off the idea of getting a battery pack for now and just use reflectors and speedlights on location like I have always done. That way I could concentrate on getting a few RX units for inside my home studio... that I could use on location as well if there is AC. I don't like the idea of pluggin the RX's into an accu like the Explorer because it hurts performance too much. But maybe I will have to give it a try...
I appreciate your Broncolor recommendation, but it isn't widely serviced or sold where I come from (as is Hensel for that matter). As far as I am concerned, I'd rather stick to either Profoto, Elinchrom or Bowens because of this.
At the moment I am more confused than ever on what to buy...
blob loblaw wrote:
That first example pic shows it's ISO 800. Why would you use such high ISO while shooting wide open and using studio lights?
Both are shot with natural light and reflectors only... no strobes were used. I posted them just to illustrate for what kind of shots I want to use a battery pack. Like I said, I have managed with reflectors and speedlights up till now... But I like the idea of a more powerful battery pack because it is more powerful and faster than speedlights and I get to use some great modifiers. Unfortunately I won't be better off regarding the modelling lights...
Daan, if most of your shooting is on location, then definitely get a pack and head system. There is no comparison! I have Elinchrom RX600 strobes and a Ranger kit, and for location shooting the Ranger is king. I love my RX strobes inside the studio, but the Ranger makes life simple when shooting on location. I have lugged my RX strobes for location shooting, but only when mains power is available, and even then it can be a pain and slow things down when setting up. For quick location setup, I love my Ranger. No need to wonder whether I have enough extension cords, making sure people don't trip over them, etc. Nothing worse than tripping someone's circuit breaker when you overload their mains system with your strobes! (You never know...).
rudiphoto wrote:
Daan, if most of your shooting is on location, then definitely get a pack and head system. There is no comparison! I have Elinchrom RX600 strobes and a Ranger kit, and for location shooting the Ranger is king. I love my RX strobes inside the studio, but the Ranger makes life simple when shooting on location. I have lugged my RX strobes for location shooting, but only when mains power is available, and even then it can be a pain and slow things down when setting up. For quick location setup, I love my Ranger. No need to wonder whether I have enough extension cords, making sure people don't trip over them, etc. Nothing worse than tripping someone's circuit breaker when you overload their mains system with your strobes! (You never know...)....Show more →
Yeah my thoughts exactly
How do you cope with the weak modelling lights of the Ranger? Or don't you use them at all?
The more I think about it, the battery pack + monolights option would still be the most suitable option for my needs.
But which option would that be?
1) Pro B2 + next years new Profoto monolights?
2) Pro B2 + RX?
3) AcuteB 600 + next years new Profoto monolights?
4) AcuteB 600 + RX?
5) Ranger RX AS + RX?
6) RX + speedlights/reflectors?
