Okay, I would have thought I could find stuff on the web for this, but I wasn't finding anything specific to what I want to do, so I figure I will toss the question up and see if anyone can help me.
Here is what I have and want to do.
One Canon 580ex II
Two Canon 430ex II's
1 PW Mini (on Camera - 1D MIIn)
3 PW Flex (one for each Flash)
I want to shoot in ETTL, with the 580ex in Zone A set to either EV 0 or EV -2/3
and the 2 430ex in Zone B set to EV +1
The two 430's are NOT Line of Sight to the 580ex.
I will also want to shoot is some cases with all the flashes in HyperSync mode (but not always necessary)
How would I set this up with the PW's? From what I am reading I may need an AC3 Zone Control, it's fine if I need one, but if I don't that is also fine. Do I need to use the PW software to set each Flex?
Any simple repeatable instructions will be greatly appreciated.
No special Setup needed. Simply put the Mini+AC3 on the Camera and the Flex on the flashes, choose the zone and same configuration (C1 or C2) and there you go. I think there is no special Setup necessary for Hypersync or HSS. No setup is required on the flashes (no Master/Slave setting!)
Line of Sight is not necessary as they are radio triggered.
Only software setup is to ensure that all units are at the same Firmware level.
